Tile, pipe wrap, ceilings and siding
Asbestos Removal in Rockville Centre
Material taken out wet, inside a sealed work area, so the remodel, the heating swap or the sale can carry on without dust following you through the house.
Clearing the Way for the Work You Actually Planned
Nobody sets out to hire an asbestos crew. You set out to redo a kitchen, finish a basement, replace an old boiler or get a house ready to sell, and somewhere along the way a contractor pulls up a corner of tile or looks at the white wrap on the heating pipes and stops. That pause is the right call, because intact material left alone is far less of a concern than material that is cut, sanded, drilled or torn out. Our job is to turn the pause into a plan. Once lab results confirm what contains asbestos, poly goes up on the walls and floor, every register and doorway gets a critical barrier, and an air scrubber with a HEPA filter pulls the enclosure into negative pressure so leaks run inward. The crew wets each piece with amended water while prying it loose, then double-bag it or wrap it, tape it and label it before it ever reaches the decon chamber. On a typical day that means elbow lagging on a steam line, old square floor tile glued down with tar-black adhesive, a cottage-cheese ceiling over a den, taped drywall seams, cement shingles off a side wall or the wrap around a forced-air trunk line. Plenty of older houses around Rockville Centre hide two or three of those in one cellar. After the last bag leaves, every surface gets a HEPA pass and a damp rag, and an outside technician pulls air samples. The poly stays up until those numbers pass. Then the space belongs to you, or to your contractor, again.
What a Removal Job Covers
Each project is scoped to the materials your lab results identified, and most of them include the items below.
Pipe and boiler insulation
Wrapped heating lines, elbow fittings and boiler jackets removed so a new system can go in without disturbing old lagging.
Floor tile and black mastic
Square tiles popped while damp and the dark glue stripped, leaving bare subfloor for the installer.
Popcorn and textured ceilings
The whole room enclosed, the texture misted and scraped, and every surface cleaned before clearance.
Joint compound and plaster
Walls and ceilings that tested positive removed ahead of a gut renovation or a layout change.
Siding, roofing and duct wrap
Cement shingles pried off unbroken where they allow it, misted and wrapped in poly, plus tired duct wrap in attics and cellars.
Containment and negative air
Plastic sheeting, sealed openings and HEPA filtered air so fibers stay inside the work area.
Packing and disposal
Waste sealed, labeled and hauled to a permitted facility, with records kept for your files.
Cleanup and air clearance
A HEPA pass, a damp wipe-down and an outside air sample before anybody moves back in.
How a Removal Unfolds
Confirm and scope
First the lab rules on each suspect sample. Next comes a written scope covering what will be removed, how the area will be sealed and what the clearance test needs to show, along with any state notifications the size of the job requires.
Enclose and remove
Poly walls go up, the scrubber is switched on to pull air inward, and the misting and scraping begin. Material comes off in a controlled way, goes straight into sealed bags or wrapping and leaves the enclosure only once it is packed and labeled.
Clean and clear
Inside the poly, every ledge and stud bay is HEPA vacuumed and wiped down damp. Then an outside technician then pulls air samples, and nothing comes down until they pass. From there your carpenters and plumbers pick up where they left off.
Why Homeowners and Builders Hand Us the Removal
Only what tests positive
Every line on the scope traces back to a positive lab result, never to a hunch about the age of the house.
Dust stays where it starts
With the scrubber pulling inward and the doorways taped, dinner still happens in the kitchen while the den is being stripped.
A space you can trust
The clearance test is independent, and the room is not handed back until it passes.
- Lab results first
- Sealed work area
- Amended-water misting
- Outside air sample to finish
Ready to Get the Old Material Out of the Way?
Tell us what was found and what the renovation needs to do next. We will talk through testing, containment and timing so your contractor knows when the room will be ready.